Domain Details

To rename a domain, click anywhere in the domain name, or hover over the domain name and click the pencil icon.

Click View in Dante Controller to launch Dante Controller with the relevant domain selected (you will be automatically logged in).

Settings
  • Click Advanced Settings to open the Advanced Settings page.
  • 'Clocking Type' indicates the type of clocking in use by the domain. Values are single-subnet (all devices in the domain are on the same IP subnet) and multi-subnet.
  • Click Auto-configure to automatically configure clocking for the domain. 
  • 'Grand Master' indicates the device that is currently the grand master clock for the domain.

  • 'Allow association with pre v4.0 firmware devices': Use this switch to enable legacy device support for the domain. Legacy Interop must also be enabled globally in the Network & Security settings.

Shared Audio

The Shared Audio panel lists any shared audio group configured for the domain, and allows you to edit the group.

Dante SMPTE/AES67 Sessions

If present, this section lists existing SMPTE or AES67 sessions (Tx multicast flows) that have been created using Dante Controller for Dante devices enrolled in the domain.

Click the session name to view the session descriptor.

External SMPTE/AES67 Sessions

If present, this section lists existing SMPTE or AES67 sessions that have been created using the 'Add Session' function (for non-Dante devices).

Click the session name to view the session descriptor.

Click Remove to remove a session.

Devices

The Devices field lists the devices in the domain, their enroll and connectivity states, and which IP subnet they are in.

To add devices to the domain, click Enroll Devices.

To remove devices from the domain, click Unenroll Devices.

Click a device name to view the device details for the device.

Enroll by IP Address Status

This field displays issues that were encountered during manual device enrollment by IP address - for example, IP addresses that could not be found, and devices that were not successfully enrolled.

Click Delete to cancel a pending enrollment.